Tuesday, January 3, 2017

Adding 3d Printer power control to OctoPi

AKA Hacking the TP-Link HS100

I recently got a Monoprice Select 3d Printer...  I am using Octoprint as the controlling software and loving the versatility.   Now that I can print remotely and follow the process with the webcam I quickly found that I wished I could turn the printer ON and OFF when I wasn't using it.

A quick search on amazon found the TP-Link HS100 for $30USD ($35 on .ca).

A little further digging I found George's blog and his article on decoding the HS100 protocol.


Based on this, here is my quick instructions:


  1. Aquire the HS100 and set it up on your wifi.   You do NOT need to enable remote access.
  2. Make a note of the IP address of your HS100 (i.e. Look at the DHCP table on your router)
  3. Install script on your OctoPi:
    cd /home/pi/scripts
    wget https://raw.githubusercontent.com/ggeorgovassilis/linuxscripts/master/tp-link-hs100-smartplug/hs100.sh
    chmod u+x /home/pi/scripts/hs100.sh
  4. Test your connection using the command: "/home/pi/scripts/hs100.sh IPADDRESS status" (Don't forget to enter the IP of your HS100)
  5. Create two helper scripts. Make sure to change the IPADDRESS below!:
    IP=127.0.0.1
    echo '#!/bin/sh' > /home/pi/scripts/poweron.sh
    echo '/home/pi/scripts/hs100.sh' $IP 9999 on '>/dev/null' >> /home/pi/scripts/poweron.sh
    echo '#!/bin/sh' > /home/pi/scripts/poweroff.sh
    echo '/home/pi/scripts/hs100.sh' $IP 9999 off '>/dev/null' >> /home/pi/scripts/poweroff.sh
    chmod u+x /home/pi/scripts/poweron.sh /home/pi/scripts/poweroff.sh
    
    
  6. Install the System Command plugin in OctoPi
  7. Setup two commands, one for "PowerOn" using the command "/home/pi/scripts/poweron.sh" and one for "PowerOFF" using "/home/pi/scripts/poweroff.sh
  8. Voila!

Part 2
-------

I found another article on this topic by MOCHERY BLARG who did the same thing using the Wemo plug.    He also took it a step further and integrated with the Automatic Shutdown plugin.  Here is my remix:

  1. Install the Automatic Shutdown plugin via the plugin manager
  2. SSH into your octopi (as pi)
  3. Edit /home/pi/.octoprint/config.yaml to add a new commands.  Be sure to change IP address with the address of your HS110.

  4. cd /home/pi/.octoprint
    cp config.yaml config.yaml.bkup
    sed -e'/^    systemShutdownCommand:.*$/a \    printerShutdownCommand: \/home\/pi\/scripts\/poweroff.sh' config.yaml
    
    
    
  5. Modify the automatic shutdown plugin to call your new command:
  6. cd /home/pi/oprint/lib/python2.7/site-packages/octoprint_automaticshutdown
    cp __init__.py __init__.py.orig
    sed -i "s/systemShutdownCommand/printerShutdownCommand/g" __init__.py
    
    
  7. Restart OctoPi

No comments:

Post a Comment